Use Cases
Industrial, commercial, residential, and occupied spaces
Heavy-traffic areas
Concrete repair
Moving joints
Interior and exterior applications (EZ formulation)
Poly Patch
Industrial, commercial, residential, and occupied spaces
Heavy-traffic areas
Concrete repair
Moving joints
Interior and exterior applications (EZ formulation)
Save time with rapid curing—the FC formulation is ready in just 8 minutes.
Protect joints from heavy equipment and vehicle impact with high durability.
Achieve a clean and precise application using a dual-cartridge caulking gun or dual-feed power pump.
Ensure a seamless finish by adding Poly Colorant to match surrounding surfaces.
Meet safety and environmental standards, including LEED, USDA, FDA, EPA, and SCAQMD.
• Outdoor application: If applying material outdoors, use KRETUS® Poly Patch EZ.
• Use in areas where operation temperatures remain between 20°F (-7°C) and 120°F (49°C). For lower temperatures,
contact your KRETUS® Technical Representative.
• The thicker the application, the faster it will cure. Do NOT apply any single layer thicker than 2 inches.
• Do NOT install under VCT or any nonbreathable flooring systems.
• Mixing: Use a static mixer with dual-cartridge caulking gun or dual-feed power pump to combine and dispense material.
Do NOT combine Part A with Part B by hand. Short gel time (1-2 minutes) makes manual dispensing impractical.
• Application temperatures: Material cures faster as temperature increases. Material cures slower as temperature
decreases. All times were measured and recorded under controlled lab conditions at 70°F. Working and cure times vary
based on ambient conditions. Apply material when temperature is decreasing—adhere to the KRETUS® Dew Point
Calculation Chart available at kretus.com/project-planning. If application temperatures are outside of those
recommended, contact your KRETUS® Technical Representative.
• DO NOT apply under direct sunlight. DO NOT install under inclement weather conditions.
• Coverage rates are for estimating purposes only. Factors such as waste, unusual/abnormal substrate conditions, and
other unforeseen jobsite conditions may affect actual product yields and are the responsibility of the installer.
• Complete samples and onsite mockups to ensure desired results are achieved.
• Recommended for Applicators level 4 and up. (See kretus.com/applicator-skill-level.)
Quickly fix spalls, cracks, and joints with KRETUS® Poly Patch. This rapid-setting, two-component polyurea system moves with adjacent concrete to handle heavy traffic. Available in fast-cure (FC) and slow-cure (EZ) options, it offers flexibility for indoor and outdoor applications. Apply it easily with a dual-cartridge caulking gun or dual-feed power pump.
Contractor Tip: All the components you need are available in the Poly Joint Filler Select boxed kits. These kits include two cartridges and two mixer tips for easy application. Components are also sold separately so you can mix and match for your project needs.
